ECW Moulds

First job was to get a mould made using original masters and other figures so I could put together the production moulds. Apart from tidying up the figures I've now sorted out figures for the moulds needed to complete the ECW refurbishment. 

After this, think I'll take a break on casting until some time in September!

Some of it is to rationalise moulds, putting a lot of the figures together instead of scattered. However, the EW6, musketeer in helmet (classic Roundhead figure) mould was no longer fit for purpose. 

EW15, Pikeman armoured in hat at rest and EW16 Pikeman unarmoured with plumed helmet at rest. These two didn't have moulds attached to them so I looked at a master mould that had some pikes on. The pose was the same as the 'Reserve' figure so I discounted them... until I finally realised that the rest and reserve  poses were the same. So now they will be on a production mould...

This is a case of putting everything together - so I will now have a production mould with all the ECW cavalry together. Still need to do some tidying up on the figures first.

Note that the catalogue entry for this army is here - but needs completing at some time.